Thanks for taking a moment to explore common tech questions with us at QTE. But no less that the initial programmed federate. We recommend using double the programmed feed rate for back feed. Micro lift distance & Back feed rate: at any point the tool is not engages into the work it will lift up (micro lift) and feed back to it starting engagement position. For just roughing large amounts of material you can increase this number to cut cycle time but could require additional operations to rough to desired amount.ĥ. Minimum Tool path radius: Acts as the twin to step over, It controls the how small of a radius you want to cut. Stepup: Very similar to Stepdown, When cutting 3D shapes the step up will give you a reduced Cusp height when roughing angles, radius and similar features.Ĥ. Used correctly can greatly reduce cycle times and Tool wear.ģ. Stepover and Stepdown are the two parameters that make the dynamic tool path work so efficiently. Our recommend starting at no less that 4 X D to ensure success. Step down: Very similar to depth cuts in our contour tool path, this uses a percentage or hard number to control the depth of cut. 35-45% stepover is a recommended as a base line.Ģ. Stepover: This is the radial engagement of your tool, At any point your tool will never exceed this percentage. Seen in the Diagram these are the parameters to make your machine successful using the dynamic tool paths.ġ. Wear is distributed along entire tool cutting length they are designed to maximize material rates while minimizing tool wear.īenefits to gain from using High speed Dynamic tool paths include:Ĥ. Mastercam’s high speed Dynamic milling toolpaths utilize the entire flute length of their cutting tools to gain greater efficiency in milling. Below there are a few steps that should help you on your way to making sure all the proper toolpaths are put in place. With regards to Mastercam, this means making sure the Dynamic Motion is always used as smoothly as possible. As many of you have done in the past, lots of our customers call in with issues regarding the best utilization of their machines. Dynamic Machining is one of Mastercam’s Core Competencies.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |